When installing Draw-Tite trailer hitch # 76177 on your 2017 Nissan Rogue Sport you will use the included hardware on the driver's side. There are 2 bolts and 2 blocks that will get fed into the frame. The threaded ends will exit through 2 of the holes in your picture, through the holes in the hitch, and secured with washers and nuts.
If you plan on doing some towing I recommend etrailer ball mount kit # 989900. It comes with 2 ball mounts; one with a 3/4 inch rise or 2 inch drop and one... view full answer...
I have linked a video below showing the installation of the T-One Vehicle Wiring Harness # 118757 on a 2017 Nissan Rogue Sport. In the video he shows taping into a factory wire which is already ran to the front fuse panel. This will save you from having to run a wire under the vehicle to the battery location at the front of your Nissan.
You will be able to install the Curt T-Connector Vehicle Wiring Harness # C56397 you were looking at the same way. view full answer...
The Yakima BaseClip Fit Kit # Y06123 is for the front and the Yakima BaseClip Fit Kit # Y06170 is for the rear. Then you can install your Yakima BaseLine Towers Y00146 and then whatever Yakima crossbars you have. view full answer...
To install the etrailer trailer hitch receiver, part # e79YR, on a 2017 Nissan Rogue Sport there is no cutting of the bumper or fascia needed. You will need to lower the exhaust temporarily to get the hitch in place and remove the tow hooks, if you have them. The tow hooks will be permanently removed. You also need to enlarge an access hole for the hitch to be mounted. view full answer...
The Curt Trailer Hitch Receiver # C13377 will simply install to the frame rails underneath the bumper of your 2019 Nissan Rogue Sport.
I have added a link below to the installation instructions for you to check out as well. view full answer...
We do have videos for both the Curt # C13377 and Draw-Tite # 76177 on a 2017 Nissan Rogue Sport that I've linked for you to check out. I'm also linking the written instructions for you to check out so you can use both to get a good idea of how they install prior to purchasing.
If you let me know what you will be using the trailer hitch for I can make additional recommendations if necessary. view full answer...
The Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C56397 that fits your 2017 Nissan Rogue Sport will hang out of the rear hatch of your vehicle as you mentioned was the case on your BMW X3.
I have added photo which shows how the connector will rest when you are using it; when you are not using it you can simply store it wherever is most convenient for you inside the hatch of your '17 Rogue Sport. view full answer...